Preparing the access road.

Preparing the access road.

The steel-reinforced floor of the digester tank, before pouring concrete.

The steel-reinforced floor of the digester tank, before pouring concrete.

The floor of the influent reception pit, which will feed into the digester.

The steel frame of the mechanical building, which will hold the
engine-generator and other equipment.

Going Vertical in early August!

Jason Mitchell and Todd Andrews of Andgar install siding on the
mechanical building that will house the genset.

Installing siding on the mechanical building.

The interior of the mechanical building.

Inside the mechanical building: conduit for the control wiring
comes up through the floor.

Inside the mechanical building: Supply and return line
piping for the heat exchangers.

The Swaggert Brothers set concrete forms for the south end
outer walls of the digester vessel.

Setting concrete forms for the digester vessel.

Tying rebar reinforcement for the center wall of the vessel.

Spray foam insulation is staged and waiting for the
completion of the walls of the vessel.

The "acid chamber", which is the entry point for fresh cow manure and other food waste inputs in the vessel. This is where it all starts.